Winco HPS6000HE/E Instruções de Operação Página 10
- Página / 20
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
3180-00
10
60706-238
4 Turn the off/on engine switch to the on position.
5. Pull the starter grip lightly until resistance is felt,
then pull briskly.
6. When the engine starts, open the choke
gradually.
7. The engine should promptly come up to
operating speed.
NOTICE:
Do not allow the starter grip to snap back against
the engine. Return it gently to prevent damage to the
starter.
ELECTRIC STARTING (Gasoline only)
If the engine is cold and stiff or if the battery is not
fully charged, starting can be made easier by slowly
hand cranking the engine through the compression
stroke before pushing the starter switch. This permits
the starter to gain momentum before the heavy load
of the compression stroke occurs. This minimizes
the drain on the battery and improves the possibility
of starting under such adverse conditions. Always
keep the battery charged, especially during cold
weather operation.
1. Checkoillevel,rellasneeded.
2. Turn on the fuel supply by moving the fuel lever
to the “ON” position.
3. Move the choke lever to the “CLOSED” position.
To restart a warm engine, leave the choke lever in
the “OPEN” position
4. Turn the engine switch to the “on” position
5.. Operating the starter. Rotate the engine switch
brieytotheSTARTposition.Thestarterlifeis
improved by using shorter starting cycles with
time to cool off between cranking cycles. Do
not operate the starter more than 5 seconds and
wait at least 10 seconds before operating the
starter again, Repeat cycle if necessary.
6. When the engine starts, release the engine
switch, allowing it to return to the “on” position.
7. Gradually move choke to the open position as
the engine warms up..
6. The engine should promptly come up to
operating speed.
CAUTION: EQUIPMENT DAMAGE
Never permit the choke to remain on after the
engine has run for a short time. It is not necessary to
choke the engine when it is warm. Avoid over-chok-
ing.
OPERATION
SAFE OPERATING PRECAUTIONS
STARTING THE ENGINE
ELECTRIC STARTER TYPESEXCEPT ELECTRIC
STARTER TYPES
ENGLISH
OFF
OONN
MMAAXX..
1/3
POSITION
THROTTLE LEVER
ENGINE SWITCH
ON
MMIINN..
OOPPEENN
CLOSE
D
CLOSED
OOPPEENN
E
NGINE SWITCH
ENGINE SWITCH
FUEL VALVE LEVER
OONN
CCLLOOSSEEDD
C
HOKE LEVER
ON
ON
ON
ON
ON
MMIINN..
CH
OKE ROD (applicable types)
4
Before operating the engine for the first time, please review the
SAFETY INFORMATION
section on page and the
BEFORE
OPERATION CHECKS
on page .
Review the instructions provided with the equipment powered by
this engine for any safety precautions that should be observed
with engine startup, shutdown or operation.
Carbon monoxide gas is toxic. Breathing itcan cause
unconsciousness and even kill you.
Avoid any areas or actions thatexpose you to carbon
monoxide.
Move the fuel valve lever to the ON position.
To start a cold engine, move the choke lever or choke rod
(applicable types)to the CLOSED position.
Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
Some engine applications use a remote-mounted choke control
rather than the engine-mounted choke lever shown here. Refer
to the instructions provided by the equipmentmanufacturer.
To restart a warm engine, leave the choke lever or choke rod in
the OPEN position.
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer to
the instructions provided by the equipmentmanufacturer.
Turn the engine switch to the ON position.
3.
4.
1.
2.
2
3
OPERATION
SAFE OPERATING PRECAUTIONS
STARTING THE ENGINE
ELECTRIC STARTER TYPESEXCEPT ELECTRIC
STARTER TYPES
ENGLISH
OFF
OONN
MMAAXX..
1/3
POSITION
THROTTLE LEVER
ENGINE SWITCH
ON
MMIINN..
OOPPEENN
CLOSE
D
CLOSED
OOPPEENN
ENGINE SWITCH
ENGINE SWITCH
FUEL VALVE LEVER
OONN
CCLLOOSSEEDD
C
HOKE LEVER
ON
ON
ON
ON
ON
MMIINN..
CH
OKE ROD (applicable types)
4
Before operating the engine for the first time, please review the
SAFETY INFORMATION
section on page and the
BEFORE
OPERATION CHECKS
on page .
Review the instructions provided with the equipment powered by
this engine for any safety precautions that should be observed
with engine startup, shutdown or operation.
Carbon monoxide gas is toxic. Breathing itcan cause
unconsciousness and even kill you.
Avoid any areas or actions thatexpose you to carbon
monoxide.
Move the fuel valve lever to the ON position.
To start a cold engine, move the choke lever or choke rod
(applicable types)to the CLOSED position.
Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
Some engine applications use a remote-mounted choke control
rather than the engine-mounted choke lever shown here. Refer
to the instructions provided by the equipmentmanufacturer.
To restart a warm engine, leave the choke lever or choke rod in
the OPEN position.
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer to
the instructions provided by the equipmentmanufacturer.
Turn the engine switch to the ON position.
3.
4.
1.
2.
2
3
OPERATION
SAFE OPERATING PRECAUTIONS
STARTING THE ENGINE
ELECTRIC STARTER TYPESEXCEPT ELECTRIC
STARTER TYPES
ENGLISH
OFF
OONN
MMAAXX..
1/3
POSITION
THROTTLE LEVER
ENGINE SWITCH
ON
MMIINN..
OOPPEENN
CLOSE
D
CLOSED
OOPPEENN
E
NGINE SWITCH
ENGINE SWITCH
FUEL VALVE LEVER
OONN
CCLLOOSSEEDD
C
HOKE LEVER
ON
ON
ON
ON
ON
MMIINN..
CH
OKE ROD (applicable types)
4
Before operating the engine for the first time, please review the
SAFETY INFORMATION
section on page and the
BEFORE
OPERATION CHECKS
on page .
Review the instructions provided with the equipment powered by
this engine for any safety precautions that should be observed
with engine startup, shutdown or operation.
Carbon monoxide gas is toxic. Breathing itcan cause
unconsciousness and even kill you.
Avoid any areas or actions thatexpose you to carbon
monoxide.
Move the fuel valve lever to the ON position.
To start a cold engine, move the choke lever or choke rod
(applicable types)to the CLOSED position.
Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
Some engine applications use a remote-mounted choke control
rather than the engine-mounted choke lever shown here. Refer
to the instructions provided by the equipmentmanufacturer.
To restart a warm engine, leave the choke lever or choke rod in
the OPEN position.
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer to
the instructions provided by the equipmentmanufacturer.
Turn the engine switch to the ON position.
3.
4.
1.
2.
2
3
OPERATION
SAFE OPERATING PRECAUTIONS
STARTING THE ENGINE
ELECTRIC STARTER TYPESEXCEPT ELECTRIC
STARTER TYPES
ENGLISH
OFF
OONN
MMAAXX..
1/3
POSITION
THROTTLE LEVER
ENGINE SWITCH
ON
MMIINN..
OOPPEENN
CLOSE
D
CLOSED
OOPPEENN
ENGINE SWITCH
ENGINE SWITCH
FUEL VALVE LEVER
OONN
CCLLOOSSEEDD
C
HOKE LEVER
ON
ON
ON
ON
ON
MMIINN..
CH
OKE ROD (applicable types)
4
Before operating the engine for the first time, please review the
SAFETY INFORMATION
section on page and the
BEFORE
OPERATION CHECKS
on page .
Review the instructions provided with the equipment powered by
this engine for any safety precautions that should be observed
with engine startup, shutdown or operation.
Carbon monoxide gas is toxic. Breathing itcan cause
unconsciousness and even kill you.
Avoid any areas or actions thatexpose you to carbon
monoxide.
Move the fuel valve lever to the ON position.
To start a cold engine, move the choke lever or choke rod
(applicable types)to the CLOSED position.
Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
Some engine applications use a remote-mounted choke control
rather than the engine-mounted choke lever shown here. Refer
to the instructions provided by the equipmentmanufacturer.
To restart a warm engine, leave the choke lever or choke rod in
the OPEN position.
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer to
the instructions provided by the equipmentmanufacturer.
Turn the engine switch to the ON position.
3.
4.
1.
2.
2
3
- HPS6000HE/I 1
- SAVE THESE INSTRUCTIONS 2
- USING THE MANUAL 2
- SAFETY INFORMATION 3
- TESTING POLICY 4
- INTENDED USES 4
- RESTRICTED USES 4
- UNIT CAPABILITIES 4
- PREPARING THE UNIT 5
- GASOLINE 6
- NG FUEL INSTALLATION 6
- Gasoline 1.67 Gal/HR 7
- Fuel Pressure Table 7
- FROM GASOLINE TO NG 8
- FROM NG TO GASOLINE 8
- OPERATION 10
- CONNECTING THE LOADS 12
- GROUNDING 13
- ENGINE CARE 14
- GENERATOR CARE 15
- CLEANING 15
- TROUBLESHOOTING 16
- WIRING DIAGRAM 17
- 24 MONTH LIMITED WARRANTY 18
- WARRANTY STATEMENT 19
- 60706-238 20
Manuais e produtos relacionados com Geradores de energia Winco HPS6000HE/E
(16 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.049 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais